How do I install the LED diffuser strip in the light box
The lamp strip configuration in the lamp box is based, the influence of the lamp strip arrangement on the effect of the whole lamp box is obvious, configuration is improper can appear the problem such as sparerib grain, dark spot, how to configure? The configuration of LED light bar is determined by various factors, such as different occasions, different brightness requirements and thickness and size of the light box. The following is a brief introduction of how to configure LED light bar.
(I) according to the classification of different occasions used in the light box, the configured LED light bars are also different
There are waiting hall light boxes, rolling light boxes, light poles light boxes, newspaper kiosks light boxes, such as district light boxes
This kind of light box is mainly used for large residential area, shopping center, large supermarket, school, computer city, recreation and leisure place and so on, and for this kind of light box, because its size is about 3 meters and below, the requirement to brightness is relatively low, so at present use extensively for side light source light bar. The side light source light bar is mainly suitable for the light box with the distance of beating less than 3 meters. Only the upper and lower or the left and the right side of the light bar are needed to form up and down, and the right side of the light bar is easy and convenient to install. Therefore, the side light source LED diffused reflection light bar is a very economical and simple way for this kind of light box.
Mila labrador, cabo light box, blister light box, soft membrane light box, market light box, subway light box, airport light box
Application areas are mainly distributed in the way of this kind of light boxes, streets, shopping malls outdoor light boxes, and shadow (drama), exhibition (pin), commercial downtown, railway stations, airports, docks, parks and other places, for this kind of light boxes, due to the size of the box and the thickness of each are not identical, for the brightness of the light box is required, so for this kind of light boxes in the configuration suggested that selection of back light on article LED lights, characteristic of the article LED lights is very flexible and can meet the demand of different light box size, different brightness and different application scenarios of lighting lighting, if it is outdoor light boxes, also can do the waterproof effect, It has a wide range of applications.
The number and spacing of light bars shall be different according to the thickness, size and brightness of the light box
This is mainly for LED shutter lamp strips. At present, the main sizes on the market are 50cm, 60cm, 80cm, 100cm and 120cm. The spacing of light bars is also very large, such as 5cm, 6.5cm, 7cm, 10cm and 15cm. If higher requirements for the brightness of the light box, can increase the number of article lamp or properly use high brightness of the light bead, if for the brightness of the light box, general quality requirements can also be appropriate to reduce the number of lights, already achieved the purpose of cost reduction, article LED book light still more flexible in size, the configuration of the LED lamp, only need light box spacing thickness can be less than light box.
