Welcome to Shenzhen Blue King Photoelectricity Co., Ltd
Back List
Current Position:Home > News > Industry trends
Installation method of LED soft light bar
From:2018.11.08
                                          Installation method of LED soft light bar
LED soft light bar with pure color, brilliant color, high brightness, energy saving and environmental protection, long life, safety and reliability, gradually emerging in the decoration industry. Since the LED soft light bar is a new product introduced in recent years, some customers have not contacted it, and it is not clear how to install it. Let's share the installation method of LED soft light bar with you.
When the LED soft light bar is used for interior decoration, the requirements for waterproof and uv protection are not high, and the installation is relatively simple. Take sunmin photoelectric LED soft light bar as an example. Each type of LED soft light bar is covered with self-adhesive 3M double-sided adhesive tape on the back. When installed, you can directly tear off the sticker of 3M double-sided adhesive surface. As for some places that require a turn or an LED soft light bar length is inconsistent. The LED soft light bar is a circuit structure composed of 3 leds in series and parallel, each of which can be cut, long can be cut off, and short can be welded on.
When used for outdoor use, the flexible LED light bar will be corroded by rain water and ultraviolet light. If it is fixed with 3M adhesive, the weak LED light bar will fall off after a long time. Therefore, the installation of flexible LED light bar in outdoor use is often fixed by stuck slots. Where shear and connection is required, the method is the same as indoor installation, only with additional waterproof glue to consolidate the waterproof effect of the joint.
Generally, the voltage of LED soft light bar is dc 12V, so it is necessary to use switch power supply for power supply. The size of power supply is calculated according to the power and length of LED soft light bar. You can also buy a power switch to make the total power, all the LED soft light bar input power supply parallel (if the wire size is not enough can be extended), unified by the total power supply. The advantage of this method is that it can be centrally controlled, and the inconvenience is that it cannot realize the lighting effect and switch control of a single LED soft light bar, which method can be measured by itself.
The LED runner bar and RGB bar need to use the controller to achieve color changing effect, but the control distance of each controller is different. Generally speaking, the control distance of simple controller is 10 to 15 meters, the control distance of remote controller is 15 to 20 meters, and the longest can be controlled to 30 meters. If the connection distance of the LED soft light bar is long and the controller cannot control such a long light bar, then a power amplifier needs to be used for taping.
About the connection distance of LED soft light bar. The maximum connection distance of 3528 patch series LED soft light strips is 20 meters, and the maximum connection distance of 5050 patch series LED soft light strips is 10 meters. If the connection distance is beyond that, the LED soft light bar can easily heat up, which will affect the service life of the LED soft light bar. Therefore, the installation must be done in accordance with the manufacturer's requirements, do not allow the LED soft light bar to run over the load.