Installation and wiring skills of LED exposed light
LED exposed light is also known as LED perforated light. The operation of LED exposed light is very simple, as long as the LED exposed light is installed in the corresponding place and then connected to the wire, so now the LED exposed light with guaranteed quality has gradually replaced the previous three-light LED film group. So, what are the wiring tips when installing LED external lights?
1. The thread heads should be concentrated
To install blue LED visible light scene when you need to set the appropriate solution, and at the time of connection to LED visible light extends as far as possible to do around and will be 9 mm the thrum of the visible light is concentrated in the middle as far as possible, so convenient for bus access, and also can effectively ensure the leakage lamp installed after each section of the line can work independently, thus more conducive to the maintenance of the late also.
2. Control the power of the exposed lamp
In view of the blue LED visible light wiring, exposed to light power control, normally the power to control LED visible light in transformer is less than eighty percent of the total power, because, if the power of the LED visible light is larger than the total power transformer, so it is easy to appear in later use electricity problems, whereas good control power transformer protection, avoid the happening of the accident.
Taillights should be in series
In order to ensure that each line can emit light equably, when wiring the LED exposed light, it is necessary to use the method of series connection to connect the exposed light at the tail, because the series taillight can not only maintain the light equalization but also stabilize the current better, thus effectively reducing the probability of the LED exposed light being burnt out during use.
Due to the high exposure rate of LED lamps, in order to ensure safety, we should not only purchase high-quality LED lamps from after-sales manufacturers to use, but also wiring according to the correct method to ensure that there will be no accidents on the wiring.
