LED full color exposed lamp parameters
Operating voltage: DC5V
Operating current: 0.02a
Operating temperature: -35℃--55℃
Rated power: 0.3w/piece
Waterproof grade: IP67
Pixel configuration: with the ￠8mm fog pack light inside the composition.
Shell: imported PVC raw material
Shell size: round ￠12mm
The punching requirements of the iron sheet word: the diameter of the round hole is 12mm. When installing the light, the hole position between each word must be installed according to the connection diagram, otherwise the animation effect made is misplaced.
Control system: SD card storage, a controller can control 512-8096 lights. A series of lights can achieve color gradient, jump, water, chasing, scanning and other effects. According to different installation methods, it can be composed of various dynamic effects, such as characters with different colors, picture pressing and so on. With the features of easy installation, high brightness, safety, energy saving, maintenance-free, long life and zero attenuation, it is suitable for exposing digital colorful luminous word, spray painting, plastic word, various lighting facilities of internal and external light source, dazzle color screen!
One of lamps have 50 light with the light level 3 p (Ed) rehearsal line between color of white, green and blue respectively in turn (white - 5 v for GND is negative, green for the signal lines, blue for the clock line) the inside of the lamp circuit board, there are two sides to have a black IC welding line side for signal input, there is no black IC welding line side for signal output. When installing the lamps to follow according to the given connection drawing line to install, lamp cannot short-ship or more, the light and the light input and output signal connection between attention should be paid to cannot be installed backwards, the controller's signal output line with iron words the first light of signal input connection, with a controller under the light signal (i.e., red, green, black three lines) is a string. If the same signboard USES more than one controller, a wire connection is required between the controller and the controller to achieve synchronization.
A string of up to 50 lights can be connected to the power bus at the head or tail of each series of lights. The wire diameter of the power bus can be selected according to the number of lights. During the wiring and installation of the full color lights, please do not operate with power on!
